Power acoustik amplifiers? - is a zx1000 1 ohm stable
Power Acoustik amps are good?
I was previously with a kicker amplifier zx1000.1 but I sold and I, with a 15 "L7
Now I'll have 2 12 "Type R and the wire into 4 ohms for 1700 watts RMS
The amp I want is a BAMF 5500
5500W Max Monoblock Class D amplifier
RMS Power Rating:
Chan 4 ohms: 1700 watts x 1.
Chan 2 ohms: 2300 watts x 1.
Chan 1 ohm: 3200 watts x 1.
Maximum Power-chan: 5500 watts x 1.
Fully regulated PWM power supply
Low level of the wired remote control included
System Distress Indicator
Four way protection circuits
Adjustable Tuned Bass EQ (0-18 dB bass boost)
Hi-speed digital circuits
Full Selectable Crossover (HI, full, low
1-ohm stable
Full Selectable Crossover (HELLO, Full, Low)
To dispel die-cast aluminum heat sinks for thermal mass of the three sides of the amplifier
Heavy Aluminum Heatsink objective ally of the division or high-density-dome convection heat sink for extreme heat dissipation
Platinum-plated RCA level inputs
Platinum-plated screw terminals
Variable low-pass filter (40-200 Hz, 12 dB / octave)
Variable subsonic filter (20-50 Hz)
Variable Subwoofer EQ @ 45Hz
Frequency response: 20-200 Hz
Signal to Noise Ratio: 100 dB
Dimensions: 9-1/4 "L x 17" W x 2-1/4 "H
Amp are correct? Is this a good game?
Friday, February 19, 2010
Is A Zx1000 1 Ohm Stable Power Acoustik Amplifiers?
Subscribe to:
Post Comments (Atom)
1 comments:
A few U-boats with DVC 2-ohm coils can be connected in a 2-ohm load or a load of 0.5 Ohms. For a 4-ohm load requires dual 4 ohm version.
The 12 "Type R's with 500 watts RMS. Two of them were 1000 watts RMS. This amp is rated too powerful for a pair 12" submarine-type R, if it makes the power. Not sure if the BAMF Series, but evaluates the other Power Acoustik only about 80%.
Another would ZX1000.1 kicker for a few U-Boats Type R Dual 2-Ohm or MRP-M1000 Alpine PDX-1.1000, or perfect.
Post a Comment